Canneed CVG-100 and CVG-200 Canners Vacuum Gauge
Used to measure the vacuum pressure of seamed cans. The gauge is placed on top of the can and the piercing needle is forced through the top of the can. The rubber collar forms a temporary seal to allow for measurement.
...
The "CanNeed Model 7001 CO2 tester and Pressure Tester" is used to test carbonated beverages
for volumes of CO2 gas in glass/PET bottles and cans.
This instrument uses a pressure gauge (0-0.4Mpa or 0.6Mpa)
It is available in one and two litre sizes. The sample is lifted easy to be pierced. ...
The Canneed "L-100 CO2 Purity Tester "consists of a caustic reservoir and calibrated absorption burette mounted to a PVC polished frame. The reservoir and burette are held to the frame with two neoprene covered mounting bands that are adjustable from the rear side of the frame. The absorption burettes are available in five different calibrations, with the standard burette graduated in tenths of one percent, the total being one percent of the volume of the burette. ...
The "canneed AXL-4000 Axial Load Tester" measures the axial force resistance of beverage cans in Newton. The can is placed in a support and gradually forced upwards against the pressure plate. The space between the support and the top plate can be altered with spacers. The can crashes after the peak force has been applied that the can is capable of resisting. The maximum value can now be read in the display. ...
Measure Topwall Thickness and Midwall Thickness with this gauge for Trimmed 2-Piece Cans.
Available for any Trimmed 2-Piece Cans of any height, the Wall Thickness Gauge measures topwall and midwall thickness. The digital dial indicators measure to 0,001 mm (0.00005) resolution.
1) Mitutoyo Standard SPC Data Output
2) Easy to read digital display
3) Requires little training and is extremely easy touse ...
Canneed "IDG-100, IDG-200 Can Internal Diameter Gauge"
This unit serves for quickly checking the Internal Diameter of can. It is equipped with a calibration piece.
IDG-100 is for small diameter can ;
IDG-200 is for big diameter can
It is equipped with a digital dial gauge with "reset" and "preset" function, LCD display and data outlet for connecting the unit to a computer via multiplexer, if required. ...
The Canneed "EBT-100 Buckle Tester for loose ends" determines the exact pressure at which the end buckles. Any end of varying diameter may be tested: chang parts are available that can be exchanged within seconds. ...
The "Canneed model ELT 100 Leak Tester for End"is used to determine the pressure at which ends buckle. This tester is also used to test for pin hole leaks in the tab score and rivet area.
The ELT 100 applies high pressure air to the product side of and end until the end fails. Leaking spots are made visible by revealing bubbles in the water bath. The failure of an end occurs either when the end buckles or when it starts leaking; leakage is generally caused by faulty scores or rivets. ...
Canneed "LaserScore-100 Score Residue Measure System"
Non-contact and Non-Destructive Score Residual Measurement
Based on laser technology and software analysis, LaserScore-100 score residue measure system is CanNeed's non-destructive system for measuring the residual score on Ends. The system is available as a semi-automated product (the operator merely inserts the ends). The LaserScore-100 system combines ease of use and reliability with excellent repeatability and accuracy.
...
Canneed "PTG-100 Plate Thickness Gauge" serves for quickly checking the thickness of plates. The sample is presented vertically in this version. It is equipped with a digital dial gauge with "reset" and "preset" function, LCD display and data outlet for connecting the unit to a computer via multiplexer, if required. ...
]
